ccurate power measurement is an indispensable foundation for high‑quality industrial production, quality assurance and regulatory compliance. Under international quality management standards as well as regulations governing product liability and environmental protection, measuring equipment must be calibrated periodically with full traceability established to national standards. For decades, thermistor mounts have served as the primary reference standard for RF power traceability. However, development and manufacturing of new units ceased many years ago, leaving users without access to replacement parts and unable to deploy them for new frequency bands such as the D‑band.
The R&S NTS series addresses exactly this challenge: it delivers a direct, high‑performance replacement for traditional thermistor mounts. Its compact form factor integrates seamlessly into existing microcalorimeter systems with no additional base unit required. Sensors connect directly to commercially available, traceably calibrated DC nanovoltmeters, enabling laboratories to retain familiar measurement workflows. Meanwhile, dedicated R&S software support facilitates a smooth transition from thermistor‑based standards to modern thermoelectric technology.
The R&S NTS features a custom thermoelectric power detector chip developed specifically for metrology‑grade RF‑DC substitution measurements. This technology draws on Rohde & Schwarz’s more than 20 years of experience with the R&S NRP power sensor portfolio and is optimized for ultra‑high accuracy requirements. Inside the sensor are two highly symmetrical RF and DC heaters to achieve near‑perfect RF‑DC substitution. The optimized heater design delivers excellent linearity, reducing the operating‑point influence on calibration factors to the ppm level per milliwatt. Superior RF performance, including outstanding impedance matching and an extremely flat frequency response, minimizes measurement uncertainty across the full operating range. A maximum input power of up to +20 dBm paired with fast settling time further enhances usability in precision calibration environments. Additional design features reinforce its metrological positioning: four‑wire DC heater connections for precise power substitution; low‑impedance DC paths to reduce parasitic thermal losses; and an integrated temperature sensor to compensate for minor thermal effects. All models are equipped with robust push‑pull DC connectors, a low thermal mass construction and electronic device identification capability to support automated calibration sequences.
The currently released R&S NTS portfolio includes multiple coaxial models covering DC to 67 GHz, plus one waveguide model with a WR 6.5 connector supporting frequencies up to 170 GHz. Dedicated open, short and mismatch standards are also available to determine microcalorimeter correction factors. The product family will continue to expand with additional models in the future. Using the R&S NTS RF power transfer standard, users can establish and maintain full internal traceability for RF power. Combined with the R&S NRPC calibration solution, R&S NRP RF power sensors and the broad portfolio of R&S RF signal generators, Rohde & Schwarz delivers an end‑to‑end, traceable RF power calibration ecosystem for the entire calibration chain.
ritu@rituchina.com
Markting@rituchina.com
Shenzhen Headquarters: Nanshan, Liuxian Avenue, Nanshan District, Shenzhen, Guangdong Province
East Building, 1st Floor, Building 6, Phase II of Yungu Innovation Industrial Park
0755-8368 0722(8 lines)
1403880343
粤公网安备 44030502008393号